I was contacted by very pleasant gentleman who asked if I could convert a Storm Talon for him, along the lines of one he'd seen on Dakka Dakka
Absolutely! Actually it's a pretty simple conversion which should look pretty good when completed.
After assembling the cockpit area, I started in on the conversion work; the first step was to flip the tail which requires cutting the fins off of the fuselage halves. Before re-attaching, I cut the now lower fins to match the line of the trailing edge of the fuselage.
In order to ensure a strong joint and maintain alignment, I created a sort of spar from plasticard.
The fuselage halves with flipped tail:
Next, the wings for this conversion use the tail-plane of the model cut in half, and used in lieu of the little stub wings.
And the stub wings end up on the fuselage at the tail
I offered to magnetize the weapons pods; he sent some magnets, but I opted to use some from my own stock since I want to ensure a secure fit. The smaller magnets may work but I'm a bit paranoid about magnetized parts falling off. The magnets inside the pod are 6mm disks, while the magnets on the options are 3mm x 3mm disks. The magnets are slightly counter-sunk into the options and end up going into the body of the pod -- they end up interlocking as well as pulling the parts together.
Really the last thing to do is to mount the Ravenwing assault cannons on the wing-tips. One bit that original poster on Dakka failed to mention was that he did a cut and flip on the assault cannon, not hard to do as long as you're careful with the razor saw.
And the finished model with various weapon options:
Warhammer 40,000: Inquisitor Martyr Updates
2 hours ago